Connect Serial Port Using Hyperterminal

Verifying a Serial Port

The following test writes to the serial port and reads from the same port make sure you have a loopback configuration set up as described in the Serial Communication Starting Point page :

Select Start Programs Accessories Hyperterminal.

Double-click on the Hypertrm icon.

If you are asked if you would like to install a modem, select No.

You are prompted to select an icon to represent the connection you are about to define. Choose any one, and name the session.

In the next Pop-Up menu, choose direct to COMx where x is the number of the COM Port you are testing.

Set the flow control setting to None. You may leave the other settings in the next dialog box, though you can increase the speed if you like.

Select File Properties from the menu bar, select the Settings tab, and then push the ASCII Setup button.

Check the option for Echo typed characters locally.

Start typing. If you see double characters that is, you see two characters for every one you type, the serial port is setup correctly and is functional.

Configuring and Using Hyperterminal with Serial Devices. Click the drop-down arrow by Connect Using; or direct to the port you intend to use Click OK;.

Verifying a Serial Port Hyperterminal Test. You are prompted to select an icon to represent the connection you are about the serial port is setup correctly.

How To – Setup a serial Console connection using HyperTerminal You can connect a serial console to the Serial port of any of the Cyberoam appliance.

Testing a DB-9 RS-232 serial port in HyperTerminal the serial port. Use a loop-back connector if Install a wire jumper to connect the following signals.

This tutorial covers how to create a serial port connection using HyperTerminal terminal emulation software for Windows.

Aug 06, 2004  HyperTerminal is a program that you can use to connect to computer using a serial port rather than when using HyperTerminal for.